PCU9955TW,118【PDF 1/39 页】IC LED DRVR CONST CURR

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录350

[1页]2页 3页 4页 5页

PCU9955

16-channel UFm I 2 C-bus 57 mA constant current LED driver

Rev. 2 — 2 October 2012

Product data sheet

1. General description

The PCU9955 is an Ultra-Fast mode (UFm) I 2 C-bus controlled 16-channel constant

current LED driver optimized for dimming and blinking 57 mA Red/Green/Blue/Amber

(RGBA) LEDs in amusement products. Each LEDn output has its own 8-bit resolution

(256 steps) fixed frequency individual PWM controller that operates at 31.25 kHz with a

duty cycle that is adjustable from 0 % to 99.6 % to allow the LED to be set to a specific

brightness value. An additional 8-bit resolution (256 steps) group PWM controller has both

a fixed frequency of 122 Hz and an adjustable frequency between 15 Hz to once every

16.8 seconds with a duty cycle that is adjustable from 0 % to 99.6 % that is used to either

dim or blink all LEDs with the same value.

Each LEDn output can be off, on (no PWM control), set at its individual PWM controller

value or at both individual and group PWM controller values. The PCU9955 operates with

a supply voltage range of 3 V to 5.5 V and the constant current sink LEDn outputs allow

up to 40 V for the LED supply. The output current is adjustable with an 8-bit linear DAC

from 225 ? A to 57 mA.

This device has built-in open, short load and overtemperature detection circuitry. The

thermal shutdown feature protects the device when internal junction temperature exceeds

the limit allowed for the process.

The PCU9955 device is the first LED controller device in a new Ultra Fast-mode (UFm)

I 2 C-bus family. UFm I 2 C-bus devices offer higher frequency (up to 5 MHz). The UFm

I 2 C-bus slave devices operate in receive-only mode. That is, only I 2 C writes to PCU9955

are supported. As such, there are no status registers in PCU9955. The PCU9955 allows

significantly higher data transfer rate compared to the Fast-mode Plus versions

(PCA9952/55).

Software programmable LED Group and three Sub Call I 2 C-bus addresses allow all or

defined groups of PCU9955 devices to respond to a common I 2 C-bus address, allowing

for example, all red LEDs to be turned on or off at the same time, thus minimizing I 2 C-bus

commands. On power-up, PCU9955 will have a unique Sub Call address to identify it as a

16-channel LED driver. This allows mixing of devices with different channel widths. Four

hardware address pins on PCU9955 allow up to 16 devices on the same bus.

The Software Reset (SWRST) function allows the master to perform a reset of the

PCU9955 through the I 2 C-bus, identical to the Power-On Reset (POR) that initializes the

registers to their default state causing the output current switches to be OFF (LED off).

This allows an easy and quick way to reconfigure all device registers to the same

condition.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式